Saatvik Green Energy Acquires 80% Stake in Transformer Manufacturer

MERC Rejects Avaada’s ₹477 Million Change-in-Law Compensation Claim

CleanCapital Sells 120 MW Solar Project in Ohio

MERC Approves Tariffs for 8 MW Round-the-Clock Renewable Energy

EMERAM Acquires Stake in Home Energy Management Firm Solar Manager

Maharashtra Forms Panel to Review Electricity Duty on Rooftop Solar

Sterling and Wilson’s Revenue Drops 23% but Profit Surges in Q4 FY 2026

Adani Green Energy Operationalizes 292 MW Solar Project in Gujarat

EIE Renewables to Acquire 150 MWh Battery Storage Project in Bihar

MERC Approves 60 MW Wind-Solar PPA Withdrawal, Citing High Tariff


					<table id="amazon-polly-audio-table">
						<tr>
						<td id="amazon-polly-audio-tab">
							<div id="amazon-ai-player-label">Listen to this article</div>
							<div id="amazon-ai-player-container">
			<audio class="amazon-ai-player" id="amazon-ai-player" preload="none" controls   controlsList="nodownload" >
				<source type="audio/mpeg" src="https://cms.mercomindia.com/wp-content/uploads/2025/11/amazon_polly_86377.mp3?version=1764917301">
			</audio>
		</div>
							<div id="amazon-polly-subscribe-tab"></div>
							<div id="amazon-polly-by-tab"></div>
						</td>
						</tr>
					</table><p>Researchers at the University of New South Wales (<a href="https://www.unsw.edu.au/" target="_blank" rel="noopener">UNSW</a>) Sydney claim they have increased the efficiency of solar technology by utilizing the concept of singlet fission, increasing the theoretical efficiency limit of silicon cells to approximately 45%.</p>
<p>Singlet fission refers to a process where a single light particle, a photon, is split into two packets of energy, doubling the output of solar energy technologies.</p>
<p>The research team, known as Omega Silicon, published their findings in ACS Publications. The findings demonstrate how singlet fission works on an organic material called Dipyrrolonaphthyridinedione (DNPD), which could be mass-produced in the future for use in solar panels.</p>
<p>Ben Carwithen, a postdoctoral researcher at UNSW’s School of Chemistry, stated that a considerable amount of the energy from sunlight in solar cells is wasted as heat, which is itself a form of energy. The Omega Silicon team is exploring ways to convert wasted energy into additional electricity.</p>
<p><strong>How the Technology Works</strong></p>
<p>A majority of solar panels today are made from silicon, a material that is affordable and reliable. However, this technology suffers from some limitations. The best commercial silicon cells currently convert only about 27% of sunlight into electricity, with the technology’s theoretical limit capping at approximately 29.4%.</p>
<p>Ned Ekins-Daukes, project lead and head of UNSW’s School of Photovoltaic and Renewable Energy Engineering, stated that introducing singlet fission into a silicon solar panel will increase its efficiency as the process enables a molecular layer to supply the panel with additional current.</p>
<p>As part of the singlet fission process, researchers added a layer of DNPD over a conventional silicon solar cell. When sunlight hits the DNPD layer, a single high-energy photon produces two lower-energy excitations. This means the solar cell can produce two usable energy packets instead of just one.</p>
<p>UNSW said finding the right material has been a challenge until now. Other teams working to address this challenge earlier had used a compound called tetracene. This material performed well in labs but degraded too quickly in air and moisture for practical use.</p>
<p>Omega Silicon said its research demonstrates how DNPD can perform equally well while maintaining stability under real-world outdoor conditions.</p>
<p>“We have shown that you can interface silicon with this stable material, which undergoes singlet fission, and then injects extra electrical charge,” said Carwithen.</p>
<p>He added that although these findings are an early step, they are the first demonstrations that can work in a realistic system.</p>
<p><strong>Adding to Previous Work</strong></p>
<p>According to UNSW, Omega Silicon’s discovery builds on over a decade-long research effort led by Tim Schmidt, head of UNSW’s School of Chemistry. His team had utilized magnetic fields to reveal a key pathway to the singlet fission process.</p>
<p>“We used magnetic fields to manipulate the emitted light and reveal how singlet fission occurs. This had not been done before,” said Schmidt.</p>
<p>Researchers leveraged their understanding of the underlying physics from Schmidt’s earlier research to design improved materials and layer structures, enhancing the effectiveness of singlet fission.</p>
<p>Schmidt explained, “Different colors of light carry different energies. Blue light has more energy, but most of that gets lost as heat in a normal solar cell. With singlet fission, that excess energy can be turned into usable electricity instead.”</p>
<p>This research is part of a broader initiative across Australia to increase the efficiency and affordability of solar energy.</p>
<p>Earlier, a team of researchers from UNSW and the Chinese solar module manufacturer LONGi discovered that the rear side of TOPCon cells, particularly the silicon nitride layer, is prone to chemical degradation when exposed to sodium-based salts, leading to a significant loss of open-circuit voltage.</p>


Singlet Fission Can Enhance Silicon Solar Cell Efficiency: Research


					<table id="amazon-polly-audio-table">
						<tr>
						<td id="amazon-polly-audio-tab">
							<div id="amazon-ai-player-label">Listen to this article</div>
							<div id="amazon-ai-player-container">
			<audio class="amazon-ai-player" id="amazon-ai-player" preload="none" controls   controlsList="nodownload" >
				<source type="audio/mpeg" src="https://cms.mercomindia.com/wp-content/uploads/2024/04/amazon_polly_64972.mp3?version=1712032882">
			</audio>
		</div>
							<div id="amazon-polly-subscribe-tab"></div>
							<div id="amazon-polly-by-tab"></div>
						</td>
						</tr>
					</table><p>A team of scientists from <a href="https://www.csiro.au/en/" target="_blank" rel="noopener">CSIRO</a>, the Australian National Science Agency, have reported a new record efficiency in roll-to-roll fully printed solar cells.</p>
<p>In a paper published in <em>Nature Communications</em> journal, the team demonstrated performances for solar cells of 15.5% efficiency on a small scale and 11% for a 50 cm2 module, a record for fully printed solar cells containing perovskite.</p>
<p>While silicon solar panels are rigid and heavy, printed solar cells are highly flexible and portable and have a wide range of applications ranging from urban construction, mining operations, emergency management, disaster relief, and space to defense and personal electronics.</p>
<p>The flexible solar cells were produced using a method in which all components of the device were fully printed from inks. Carbon-based inks were used to replace gold in the solar cell, dramatically reducing the cost while maintaining high performance.</p>
<p>The solar cells were printed using roll-to-roll techniques, which can be used to print solar cells on a long, continuous roll of plastic.</p>
<p>This lightweight and flexible solar technology, printed onto thin plastic films, is expected to expand solar cell usage and meet the growing demand for renewable energy.</p>
<p>&#8220;CSIRO&#8217;s thin and lightweight solar cells are now on the cusp of emerging from the lab to create clean energy in the real world. Roll-to-roll printing allows for the solar cells to be manufactured on very long, continuous rolls of plastic, which can dramatically increase the rate of production,&#8221; said the agency&#8217;s Renewable Energy Systems Group Leader Anthony Chesman.</p>
<p>The team, which collaborated with researchers from the <a href="https://www.cam.ac.uk/" target="_blank" rel="noopener">University of Cambridge</a>, <a href="https://www.monash.edu/" target="_blank" rel="noopener">Monash University</a>, the <a href="https://www.sydney.edu.au/" target="_blank" rel="noopener">University of Sydney</a><u>,</u> and the <a href="https://www.unsw.edu.au/" target="_blank" rel="noopener">University of New South Wales</a>, solved several engineering problems across a large surface area of interconnected modules to achieve record results.</p>
<p>&#8220;We developed a system for rapidly producing and testing over ten thousand solar cells a day – something that would have been impossible to do manually. We&#8217;ve also alleviated the need to use expensive metals, such as gold, in their production by using specialized carbon inks, which further reduces production costs,&#8221; stated Principal Research Scientist Doojin Vak.</p>
<p>Incorporating an advanced material called perovskite, CSIRO&#8217;s printed solar panels differ from the silicon solar panels found on Australian roofs. &#8220;Our thin, lightweight solar can be easily transported anywhere there is sun,&#8221; he said.</p>
<p>The team also sent the solar panels to space to test their performance, to further optimize and provide a reliable energy source for future space endeavors.</p>
<p>Recently, scientists from the National University of Singapore <a href="https://www.mercomindia.com/record-efficiency-tandem-solar-cell" target="_blank" rel="noopener">announced</a> a record energy conversion efficiency of 27.1% from a novel triple-junction solar cell, which promises to overcome current limitations in solar technology.</p>
<p>Earlier this year, researchers also <a href="https://www.mercomindia.com/bulky-molecules-perovskite-solar-last-longer" target="_blank" rel="noopener">found</a> that adding bulky molecules can make perovskite solar cells last longer, surpassing silicon solar cells&#8217; maximum theoretical efficiency.</p>


Australian Scientists Report Record 15.5% Efficiency for Printed Solar Cells

university-of-new-south-wales

Get the most relevant India solar and clean energy news.

RECENT POSTS